3Com VCX V7000 Installation Manual page 377

DISCONNECTONBUSYTONE = 0
ISPROXYUSED = 1
AUTHENTICATIONMODE = 0
ISWAITFORDIALTONE = 1
ISTWOSTAGEDIAL = 0
ENABLECURRENTDISCONNECT = 1
CDRREPORTLEVEL = 2
Sample V6100 Media Gateway Configuration File
Set this parameter to control whether an FXO call is released when either
Busy or Fast Busy tones are detected.
0 — Do not release the call when Busy or Fast Busy is detected.
■
1 — Release the call when Busy or Fast Busy is detected.
■
Define whether a proxy server is used (1) or not (0). NOTE: If no proxy is
used, you must configure the "Tel to IP Routing" table.
Set the authentication mode for the Media Gateway. Possible values are:
0 — Registration and authentication occur for each endpoint.
■
1 — Registration and authentication occur once for the gateway.
■
2 — Not applicable to the V6100.
■
3 — (Default) Registration and Authentication occur for FXS endpoints
■
only.
Specify whether outbound calls over FXO ports occur immediately after
the port seizes the PSTN line (0) or after the port detects dial tone
(1, default).
Enable one-stage dialing (0) or two-stage dialing. In one-stage dialing the
FXO module connects the user to the telephone company's equipment
and the user then dials the destination number. In two stage dialing (1)
the FXO module waits until the user has dialed a number and then passes
the number to the telephone company equipment. Two-stage dialing is
the default.
Enable (1) or disable (0, default) the disconnection of calls when the FXO
module detects the current disconnect signal.
Determine the amount of Call Detail Record inforamation that is sent to
the Syslog Server. Possible values are:
0 — No information is sent (default).
■
Configuration Files 375