3Com VCX V7000 Installation Manual page 207

Post-Installation
Steps
vcx-setup
Sample Network Configuration Script — IP Messaging Client
---------------------------------------------------------------------------
------------- Welcome to the VCX Network Configuration Wizard -------------
---------------------------------------------------------------------------
This wizard sets up networking and related services.
Configure networking now? [yes] :
--------- Configuring Dynamic Host Configuration Protocol (DHCP) ----------
VCX servers can use DHCP for automated configuration, but this requires
that the DHCP server is configured to provide the proper options.
you know that your environment is set up in this way, you should say 'no'
here and configure static network parameters.
Use DHCP on eth0 to configure network parameters? [yes] : no
-------------------------- Configuring Hostname ---------------------------
Enter system hostname
After you install a branch office IP Messaging system, you must define the
branch office server as a trusted end point on the VCX Authentication
and Directory server in the associated regional office.
For instructions on how to add trusted endpoints, see the VCX
Administration Guide.
Configuring a IP Messaging Client
To begin the configuration process, enter this command:
The network configuration portion of the script starts.
Press the Enter or Return key to accept the suggested answer (yes).
IP addresses for VCX servers must be static addresses. Enter no to
configure the network parameters for eth0 manually.
:
Enter the name that you want to use for this branch office server.
Unqualified host names must conform to the rules outlined in
Names" in Chapter 1.
207
Unless
"Host