3Com VCX V7000 Installation Manual page 434

432 A C: R
PPENDIX EPLACING A
Instructions
(Single Site,
Four Servers)
F D VCX S
AILED ISK ON A
Use the instructions in this section to replace the disk on a:
Primary or Secondary IP Telephony Server
■
Primary or Secondary IP Messaging Server
■
1 If the server is configured for RAID operation, see
earlier in this appendix.
1 Replace the failed disk.
a Remove power from the down server.
b Remove the failed disk.
c Install the replacement disk.
d Apply power to the server.
e Press the start button on the front panel.
2 Log in as root and configure the networking parameters on the down
server using this command:
vcx-config-network --wizard
If the down server is the Primary IP Telephony Server, follow the
instructions in "Configuring a Primary IP Telephony Server (Single Site)"
Chapter 3.
If the down server is the Secondary IP Telephony Server, follow the
instructions in "Configuring a Secondary IP Telephony Server (Single
Site)" in Chapter
If the down server is the primary IP Messaging Server, follow the
instructions in "Configuring a Primary IP Messaging Server"
If the down server is the Secondary IP Messaging Server, follow the
instructions in "Configuring a Secondary IP Messaging Server"
Chapter 4.
3 If necessary, upgrade the software version on the down server to match
the software version on the running server.
a Compare the software version on the down server to the software
version on the running server.
On the running server and on the down server, enter this command:
vcx-showversion
b If the down server is running an earlier software version than the
running server, download the appropriate software upgrade file to the
/opt/installtemp
ERVER
3.
directory on the down server.
"RAID Disk Failure",
in Chapter
in
in
4.