3Com VCX V7000 Installation Manual page 181

vcx-setup
Sample Network Configuration Script — Secondary IP Messaging Server
---------------------------------------------------------------------------
------------- Welcome to the VCX Network Configuration Wizard -------------
---------------------------------------------------------------------------
This wizard sets up networking and related services.
Configure networking now? [yes] :
--------- Configuring Dynamic Host Configuration Protocol (DHCP) ----------
VCX servers can use DHCP for automated configuration, but this requires
that the DHCP server is configured to provide the proper options.
you know that your environment is set up in this way, you should say 'no'
here and configure static network parameters.
Use DHCP on eth0 to configure network parameters? [yes] : no
-------------------------- Configuring Hostname ---------------------------
Enter system hostname
--------------------- Configuring IP Interface 'eth0' ---------------------
IP Address
Network Subnet Mask
Default Gateway Address
Configuring a Secondary IP Messaging Server
To begin the configuration process, enter this command:
The network configuration portion of the script starts.
Press the Enter or Return key to accept the suggested answer (yes).
Enter no to specify the IP addresses manually.
:
Enter the unqualified name that you want to use for this primary server.
Unqualified host names must conform to the rules outlined in
Names" in Chapter 4.
:
:
:
Enter the IP address for this server's eth0 interface and the subnet mask
and default gateway IP address appropriate for this site.
181
Unless
"Host