3Com VCX V7000 Installation Manual page 380

378 A B: A
PPENDIX UTOMATED
PROXYREDUNDANCYMODE = 1
ALTROUTINGTEL2IPENABLE = 1
ALTROUTINGTEL2IPMODE = 3
GWAPPDELAYTIME = 5
DISCONNECTONBROKENCONNECTION = 0
B O I
RANCH FFICE NSTALLATION
Sample V6100 Media Gateway Configuration File
Enable (1) or disable (0) the gateway to always try to work with the
primary Proxy. If this parameter is set to 0 and the primary proxy fails, the
gateway continues to work with the last active proxy until a proxy failure
occurs.
Alternate routing of calls is possible if the initial destination cannot be
pinged or if poor quality of service (QoS) is detected. Possible values are:
0 — Disable alternate routing.
■
1 — Enable alternate routing
■
2 — Provide read-only information on the quality of service of the
■
destination IP address. Alternate routing is disabled.
If alternate routing is enabled, select an alternate routing mode. Possible
values are:
0 — Alternate routing is not used.
■
1 — Alternate routing is performed if a ping to the initial destination
■
fails.
2 — Alternative routing is performed if a poor quality of service is
■
detected.
3 — Alternative routing is performed if either a ping failed or poor
■
quality of service was detected.
Specify, in seconds, the amount of time that the gateway's operation is
delayed after a reset cycle. The default value is 0 (zero). NOTE: Increasing
the delay can overcome connection problems caused by some LAN
routers.
Enable (1) or disable (0) the disconnection of a call if RTP packets are not
received for a defined time period (see BrokenConnectionEventTimeout).
The default timeout value is 10 seconds. This feature cannot be used if
silence compression is enabled.