3Com VCX V7000 Installation Manual page 208

208 C 4: I
HAPTER NSTALLING AN
Sample Network Configuration Script — IP Messaging Client (continued)
--------------------- Configuring IP Interface 'eth0' ---------------------
IP Address
Network Subnet Mask
Default Gateway Address
--------------------- Configuring IP Interface 'eth1' ---------------------
Interface State
IP Address
Network Subnet Mask
Default Gateway Address
------------------------- Configuring DNS Servers -------------------------
Enter DNS servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary DNS Server
Secondary DNS Server
Tertiary DNS Server
----------------------- Configuring DNS Search Path -----------------------
Press Enter to leave the current path unchanged, or specify
a new search path, with spaces separating each entry.
DNS Search Path :
-------------------- Configuring Network Time Protocol --------------------
Enter NTP servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary NTP Server
Secondary NTP Server
IP M S
ESSAGING ERVER
:
:
:
Enter the IP address for this server's eth0 interface and the subnet mask
and default gateway IP address appropriate for this site.
: enabled
Change the default value (disabled) to enabled.
:
:
:
Enter the IP address for this server's eth1 interface and the subnet mask
and default gateway address appropriate for this site.
:
:
:
Enter up to three DNS server IP addresses.
Enter the DNS search path appropriate for this site.
:
:
Enter one or two NTP server IP addresses.
CAUTION: If VCX systems are not synchronized via NTP, timing-related
problems can occur.