3Com VCX V7000 Installation Manual page 358

356 A B: A
PPENDIX UTOMATED
Sample V6000 Media Gateway Configuration File (continued)
PLAYRBTONE2IP = 1
ISSPECIALDIGITS = 1
REGISTRATIONTIME = 3600
DISCONNECTONBUSYTONE = 0
ISPROXYUSED = 1
ISREGISTERNEEDED = 1
B O I
RANCH FFICE NSTALLATION
Set this parameter to control whether the ringback (RB) tone is played on
the IP side of a call. Possible values are:
0 — Don't play ringback tone
■
1 — Ringback tone is played after the SIP 183 session progress
■
response has been sent.
NOTE: To enable the Media Gateway to send a 183 response, set
EnableEarlyMedia to 1.
NOTE: If EnableDigitDelivery is set to 1, the Media Gateway does not play
ringback tones and does not send a 183 response.
Enable (1) or Disable (0) the use of the star (*) or pound/hash (#) buttons
during the dialing of a number. NOTE: If you disable this feature, users
can still press either of these two keys as the first key in a dialing
sequence.
Set the duration (in seconds) of the registration of a SIP telephone. The
default value is 3600 (1 hour).
Set this parameter to control whether an FXO call is released when either
Busy or Fast Busy tones are detected.
0 — Do not release the call when Busy or Fast Busy is detected.
■
1 — Release the call when Busy or Fast Busy is detected.
■
Define whether a proxy server is used (1) or not (0). NOTE: If no proxy is
used, you must configure the "Tel to IP Routing" table.
Define whether the Media Gateway registers (1) with the proxy each time
that it is powerd up and when each registration interval expires, or does
not (0) register.