3Com VCX V7000 Installation Manual page 102

102 C 2: I
HAPTER NSTALLING AN
Sample Network Configuration Script — Branch Office Server (continued)
--------------------- Configuring IP Interface 'eth0' ---------------------
IP Address
Network Subnet Mask
Default Gateway Address
--------------------- Configuring IP Interface 'eth1' ---------------------
Interface State
------------------------- Configuring DNS Servers -------------------------
Enter DNS servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary DNS Server
Secondary DNS Server
Tertiary DNS Server
----------------------- Configuring DNS Search Path -----------------------
Press Enter to leave the current path unchanged, or specify
a new search path, with spaces separating each entry.
DNS Search Path :
-------------------- Configuring Network Time Protocol --------------------
Enter NTP servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary NTP Server
Secondary NTP Server
IP T M
ELEPHONY AND ESSAGING
:
:
:
Enter an IP Address, Network Subnet Mask, and Default Gateway
Address that are appropriate for this branch office.
: disabled
A branch office VCX server uses only the eth0 network interface. Press
the Enter or Return key to accept the default answer (disabled).
:
:
:
Enter the IP addresses for up to three Domain Name Service (DNS)
servers. The script interprets a 0.0.0.0 address as the end of the list.
Enter the DNS search path appropriate for the domain for the branch
office (for example, yourdomain.com).
:
:
Enter the IP addresses for up to two Network Time Protocol (NTP) servers.
The script interprets a 0.0.0.0 address as the end of the list.
CAUTION: If VCX systems are not synchronized via NTP, timing-related
problems can occur.
S
ERVER