3Com VCX V7000 Installation Manual page 244

244 C 6: I
HAPTER NSTALLING A
Sample Network Configuration Script — Call Records Server (continued)
Configure networking now? [yes] :
--------- Configuring Dynamic Host Configuration Protocol (DHCP) ----------
VCX servers can use DHCP for automated configuration, but this requires
that the DHCP server is configured to provide the proper options.
you know that your environment is set up in this way, you should say 'no'
here and configure static network parameters.
Use DHCP on eth0 to configure network parameters? [yes] : no
-------------------------- Configuring Hostname ---------------------------
Enter system hostname
--------------------- Configuring IP Interface 'eth0' ---------------------
IP Address
Network Subnet Mask
Default Gateway Address
--------------------- Configuring IP Interface 'eth1' ---------------------
Interface State
IP Address
Network Subnet Mask
Default Gateway Address
------------------------- Configuring DNS Servers -------------------------
Enter DNS servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary DNS Server
Secondary DNS Server
Tertiary DNS Server
C R S
ALL ECORDS ERVER
Press the Enter or Return key to accept the suggested answer (yes).
Enter no to specify the IP addresses manually.
:
Enter the unqualified name that you want to use for this primary server.
Unqualified host names must conform to the rules outlined in
Names" in Chapter 6.
:
:
:
Enter the IP address for this server's eth0 interface and the subnet mask
and default gateway IP address appropriate for this site.
: enabled
Change the default value (disabled) to enabled.
:
:
:
Enter the IP address for this server's eth1 interface and the subnet mask
and default gateway address appropriate for this site.
:
:
:
Enter up to three DNS server IP addresses.
Unless
"Host