3Com VCX V7000 Installation Manual page 359

Sample V6000 Media Gateway Configuration File (continued)
AUTHENTICATIONMODE = 0
ISWAITFORDIALTONE = 1
ISTWOSTAGEDIAL = 0
ENABLECURRENTDISCONNECT = 1
ENABLEHOLD = 1
ENABLEFORWARD = 1
Set the authentication mode for the Media Gateway. Possible values are:
0 — Registration and authentication occur for each endpoint.
■
1 — Registration and authentication occur once for the gateway.
■
2 — Not applicable to the V6000.
■
3 — (Default) Registration and Authentication occur for FXS endpoints
■
only.
Specify whether outbound calls over FXO ports occur immediately after
the port seizes the PSTN line (0) or after the port detects dial tone
(1, default).
Enable one-stage dialing (0) or two-stage dialing. In one-stage dialing the
FXO module connects the user to the telephone company's equipment
and the user then dials the destination number. In two stage dialing (1)
the FXO module waits until the user has dialed a number and then passes
the number to the telephone company equipment. Two-stage dialing is
the default.
Enable (1) or disable (0, default) the disconnection of calls when the FXO
module detects the current disconnect signal.
Enable (1) or disable (0, default) the ability of users to perform a
hookflash to place a call on hold and retrieve a call from hold.
NOTE: Gateways at both ends of the call must be configured to support
this feature.
Enable (1) or disable (0, default) the ability of users to forward a call.
NOTE: Gateways at both ends of the call must be configured to support
this feature.
NOTE: For FXS modules a Call Forward table must be defined.
Configuration Files 357