Gateway Installation; 3Com V7111 Analog Gateways - 3Com VCX V7000 Installation Manual

Gateway
Installation
3Com V7111 Analog
Gateways
This command enables VLAN operation on the virtual LAN with ID = 2.
vcxSetVlanConfig 0
This command disables VLAN operation.
To verify the current settings use the vcxShowConfig command.
14 Enter this command to restart the Attendant Console:
vcxReset
This command copies the contents of the non-volatile memory to the
active network settings for the Attendant Console.
The Attendant Console communicates with the Primary VCX Server. Use
the Administrator Interface to:
Verify that the Attendant Console has been discovered by the VCX
■
system
Perform the remaining configuration of the Attendant Console
■
Associate the Attendant Console with a particular phone
■
For instructions on how to perform these tasks, see the VCX
Administration Guide.
V7111 Analog Gateways connect the VCX system in two directions:
FXO versions connect to analog trunk lines from the Public Switched
■
Telephone Network (PSTN).
FXS versions connect to analog telephones or fax machines.
■
There are 4-port and 8-port FXO versions of the V7111.
There are 2-port, 4-port, 8-port, and 24-port FXS versions of the V7111.
In addition, one model of the V7111 has 4 FXO ports and 4 FXS ports.
To configure any V7111 analog gateway, use a browser to connect to the
gateway. Read and follow the instructions in the 3Com VCX V7111 Fast
Track Installation Guide.

Gateway Installation

305