Replacing The Ufm - Fujitsu PRIMERGY TX200 S6 Service Supplement Manual

Replacing the UFM

Ê Reinstall the system fan 2 (or 2&4) (for a detailed description see the
Options Guide).
Ê Close the server and connect all power plugs (for a detailed description see
the Options Guide).
4.10 Replacing the UFM
UFM is the short form for USB Flash Module.
Ê Open the server as described in the
Ê Remove the system fan 2 (or 2&4) as described in the
the system fan 2 (or 2&4)" on page
Figure 24: Removing the UFM
Ê Remove the nylon screw of the defective UFM (1).
Ê Disconnect and remove the defective UFM (2).
The UFM spacer remains on the system board.
44
section "Preparation" on page
25.
Service Supplement
23.
section "Removing
TX200 S6