Replacing The Ufm Board - Fujitsu PRIMERGY TX300 S5 Service Supplement Manual

Replacing the UFM board

4.12 Replacing the UFM board
Ê Open the server as described in
Ê Remove the PSU cage as described in
on page 28.
Figure 71: Removing the UFM board
Ê Remove the nylon screw on the defective UFM board (1).
Ê Disconnect and remove the defective UFM board (2).
The UFM spacer remains on the system board.
76
section "Preparation" on page
section "Replacing PSU riser cards"
2
Service Supplement
Replacement routines
17.
1
PRIMERGY TX300 S5