Step 3. Connecting The Device Under Test(Dut) - Agilent Technologies ENA Series Installation And Quick Start Manual

STEP 3. Connecting the Device Under Test(DUT)

Step 1. Connect t the DUT to the E5061A/E5062A. (See Figure 3-15.)
Figure 3-15 Connecting the DUT
NOTE
Applying the setting value for the power level (-5 dBm) may destroy some DUTs. Should
this occur, first select the proper power level and then connect the DUT to the
E5061A/E5062A.
Step 2. Set the appropriate scale by executing the auto scale. (See Figure 3-16.)
•
[Scale] - Auto Scale
You can also adjust the scale by entering arbitrary values in the
Reference Position
Figure 3-16 S21 trace after executing the auto scale
Chapter 3
Measurement Example of a Bandpass Filter
button, and Reference Value
Quick Start Guide
button,
Scale/Div
.
55