Servicing
Pressure Transducer Calibration
Pressure Transducer
Calibration
7-36
Model 42i Trace Level Instruction Manual
Figure 7–17. Replacing the Pressure Transducer
4. Remove the two pressure transducer assembly retaining screws and
remove the pressure transducer assembly.
5. To install the pressure transducer assembly, follow previous steps in
reverse.
6. Calibrate the pressure transducer. Refer to the "Pressure Transducer
Calibration" procedure that follows.
Use the following procedure to calibrate the pressure transducer.
Equipment Required:
Vacuum pump
WARNING The service procedures in this manual are restricted to qualified
service representatives.
If the equipment is operated in a manner not specified by the
manufacturer, the protection provided by the equipment may be
impaired.
▲
Retaining Screws (2)
Pressure Transducer Assembly
▲
Thermo Fisher Scientific