Advertisement
Operation
Instrument Controls Menu
Default Gateway
I/O Configuration
3-42
Model 42i Trace Level Instruction Manual
The Default Gateway screen is used to edit the gateway address. The
default gateway can only be changed when DHCP is OFF. For more
information on DHCP, see
that are not on the local subnet will be routed through this address.
In the Main Menu, choose Instrument Controls > Communication
●
Settings > TCP/IP Settings > Gateway.
Host Name
The host name screen is used to edit the host name. When DHCP is
enabled, this name is reported to the DHCP server.
In the Main Menu, choose Instrument Controls > Communication
●
Settings > TCP/IP Settings > Host Name.
The I/O Configuration menu deals with configuration of the analyzer's
I/O system. The analog input configuration is displayed only if the I/O
expansion board option is installed.
In the Main Menu, choose Instrument Controls > I/O Configuration.
●
Note The digital outputs may take up to one second after the assigned
state occurs to show up on the outputs.
"Use
DEFAULT GATEWAY:
CURRENT: 10.209.42.1
SET TO: 10.209.42.1
MOVE CURSOR
CHANGE VALUE
SAVE VALUE
RANGE
AVG
DIAGS ALARM
HOST NAME:
CURRENT: ISERIES
ISERIES
ABCDEFGHIJKLMN
OPQRSTUVWXYZ
0123456789 ./-
RANGE
AVG
DIAGS ALARM
DHCP" above. Any traffic to addresses
1
SSSSS
?
BKSP
PAGE
SAVE
▲
Thermo Fisher Scientific
Advertisement
Troubleshooting
