Removing An Sfp Transceiver - 3Com SUPERSTACK 3 3870 Series Getting Started Manual

5 Use and appropriate cable to connect the transceiver to a suitable device.
6 Check the LEDs on the front of the Switch to ensure that it is operating
Removing an SFP
Transceiver
1 Disconnect the cable from the transceiver.
2 Move the wire release lever downwards until it is pointing toward you.
3 Pull the wire release lever toward you to release the catch mechanism;
Figure 5 Inserting an SFP Transceiver
Product
label
correctly. Refer to "LEDs"
If you wish to remove the transceiver (it is not necessary to power-down
your Switch):
the transceiver will then easily slide out.
on page 15 for more information.
SFP Operation 29
Suitable port
on host Switch