Using The Imageshift Utility; Using The Imageshift Utility Through The Front Panel - Quantum Data 881 User Manual

Using the ImageShift utility

Using the ImageShift utility through the front panel

882 Video Test Instrument User Guide (Rev A.35)
This section describes the ImageShift utility and how to use it. The ImageShift utility allows
you to set in motion any of the built-in or bitmap static images stored in the 882. Image
shifting can be controlled at both the pixel level in horizontal and vertical directions, and on
a per frame basis. The shift pattern can be set to either a repeated pattern or back and
forth (reversed).
You can create your own imageshift files in order to specify particular image shifting
configurations to invoke. This enables you to quickly invoke an image shifting set of
parameters to apply.
The ImageShift function can be configured and run either through the front panel or the
command line. Procedures for both are provided.
The procedure for configuring and running the ImageShift utility is provided below.
To use the ImageShift utility through the front panel:
1. Physically connect a monitor to the 882 at any of the interfaces using a suitable cable.
2. Press the Tools key. The Tools menu appears on the 882's display as shown below.
System
Sequence
Probe
AFC
3. Choose ImgShift by pressing the adjacent soft key. The following menu appears on the
882's display.
Flash
Sequence
This display enables you to browse for a bitmap image or a built-in image stored in
cache.
4. Choose Cache to browse for a built-in image. The following menu appears on the 882's
display.
Images
Tools
Reports
ImgShift
Analyzer
CEC
Card
Cache
Exit!
Fonts
73