Configuring Global Mvr Settings - Edge-Core ES3510MA Management Manual

C G
ONFIGURING LOBAL
MVR S
ETTINGS
Use the Multicast > MVR (Configure General) page to enable MVR globally
on the switch, select the VLAN that will serve as the sole channel for
common multicast streams supported by the service provider, and assign
the multicast group address for each of these services to the MVR VLAN.
CLI R
EFERENCES
"Multicast VLAN Registration" on page 875
◆
C U
OMMAND SAGE
IGMP snooping and MVR share a maximum number of 256 groups. Any
multicast streams received in excess of this limitation will be flooded to all
ports in the associated VLAN.
P
ARAMETERS
These parameters are displayed:
MVR Status – When MVR is enabled on the switch, any multicast data
◆
associated with an MVR group is sent from all designated source ports,
to all receiver ports that have registered to receive data from that
multicast group. (Default: Disabled)
◆ MVR VLAN – Identifier of the VLAN that serves as the channel for
streaming multicast services using MVR. MVR source ports should be
configured as members of the MVR VLAN (see
to VLANs" on page 160), but MVR receiver ports should not be
manually configured as members of this VLAN. (Default: 1)
MVR Running Status – Indicates whether or not all necessary
◆
conditions in the MVR environment are satisfied. Running status is
Active as long as MVR is enabled, the specified MVR VLAN exists, and a
source port with a valid link has been configured (see
Interface Status" on page
MVR Group IP – IP address for an MVR multicast group.
◆
(Range: 224.0.1.0 - 239.255.255.255; Default: no groups are assigned
to the MVR VLAN)
Any multicast data sent to this address is sent to all source ports on the
switch and all receiver ports that have elected to receive data on that
multicast address.
The IP address range of 224.0.0.0 to 239.255.255.255 is used for
multicast streams. MVR group addresses cannot fall within the reserved
IP multicast address range of 224.0.0.x.
Count – The number of contiguous MVR group addresses.
◆
(Range: 1-255; Default: 0)
– 465 –
C
HAPTER
Multicast VLAN Registration
"Adding Static Members
466).
| Multicast Filtering
18
"Configuring MVR