Table of Contents
Advertisement
Instruction Manual
D103412X012
Version
Device Revision (DEV_REV [12]) is the manufacturer's revision number associated with the resource, used by an
interface device to locate the DD file for the resource.
Firmware Revision (FIRMWARE_REVISION [105]) identifies the revision of the firmware that is currently in use.
Standby Firmware Revision (STBY_FIRMWARE_REVISION [111]) identifies the revision of the alternative firmware.
Hardware Revision (HARDWARE_REVISION [83]) identifies the revision of the electronic hardware.
ITK Version (ITK_VER [41]) identifies the major version of the Interoperability Tester used by the Fieldbus Foundation
in certifying the device as interoperable. This device revision meets the requirements of version 6.
Alert Handling
Simulate Enabled/Disabled (FD_SIMULATE [73]), when enabled, allows the user to write to the following Field
Diagnostic and Instrument alert parameters; Failed Active, Maintenance Active, Offspec Active, and Check Active. This
provides a way to simulate these alerts for testing. In order to enable Field Diagnostic Alerts Simulate, the Aux
Terminal must be jumpered.
Simulate Active Alerts is cleared on a power cycle. It can also be cleared manually, or by removing the Aux terminal
jumper.
Refer to Alerts on page 54 for additional information setting Field Diagnostic and Instrument alerts.
Enable/Disable FD Simulation
All Diag Tiers FD Alerts
PST Diag Tier FD Alerts
DVC6200f Digital Valve Controller
Detailed Setup - Resource Block
February 2017
27
Advertisement
Table of Contents
Troubleshooting
