Table of Contents
Advertisement
Instruction Manual
D103412X012
Section 3 Basic
Basic Setup
Field Communicator
TB > Configure/Setup > Basic Setup
WARNING
Changes to the instrument setup may cause changes in the output pressure or valve travel. Depending on the application,
these changes may upset process control, which may result in personal injury or property damage.
When the DVC6200f digital valve controller is ordered as part of a control valve assembly, the factory mounts the
digital valve controller and sets up the instrument as specified on the order. When mounting to a valve in the field, the
instrument needs to be setup to match the instrument to the valve and actuator.
Before beginning basic setup, be sure the instrument is correctly mounted as described in the Installation section.
Basic Setup includes the following procedures:
D Device Setup
D Performance Tuner (Optional)
Note
The DVC6200f may keep the Transducer Block Mode Out‐of‐Service if the instrument is not properly mounted.
To setup and calibrate the instrument, the Transducer Block Mode must be Manual, and the Protection must be None.
When using DD methods the method will request that you change the mode, but make changes in Protection automatically. If you
have a host system that overrides transducer block parameters ensure that the Protection setting is not left as None. Doing so will
result in transducer block parameters being overwritten.
Transducer Block Mode
Field Communicator
TB > Device Variables > TB Block Mode
To setup and calibrate the instrument, the transducer block mode must be in Manual. For more information about
transducer block mode, refer to page 47.
Protection
TB > Configure/Setup > Detailed Setup > Protection
Field Communicator
To setup and calibrate the instrument, the protection must be set to None with the Field Communicator. For more
information about configuration protection refer to page 47.
Setup3-3-
DVC6200f Digital Valve Controller
Basic Setup
February 2017
17
Advertisement
Table of Contents
Troubleshooting
