Fisher FIELDVUEDVC6200f Instruction Manual page 99

Instruction Manual
D103412X012
Table 4‐12. Transducer Block Parameter Definitions
Label
PARAMETER_NAME
ACT_SIZE_ENUM
DEVICE_RECORD
Temperature Maximum
TEMP_MAX
Temperature Maximum Time
TEMP_MAX_TIME
Temperature Minimum
TEMP_MIN
Temperature Minimum Time
TEMP_MIN_TIME
Supply Pressure Maximum
SUPP_PRESS_MAX
Supply Pressure Maximum Time
SUPP_PRESS_MAX_TIME
Supply Pressure Minimum
SUPP_PRESS_MIN
Supply Pressure Minimum Time
SUPP_PRESS_MIN_TIME
Comm Error Count
COMM_ERROR_COUNT
Protection
PROTECTION
PERF_DIAG
PD Run
PD_COMMAND
PD Status
PD_STATUS
PD Configuration
PD_CONFIG
PD Extra
PD_EXTRA
Temperature Units
TEMPERATURE_UNITS
Pressure Units
TB_PRESSURE_UNITS
Length Units
LENGTH_UNITS
Area Units
AREA_UNITS
Spring Rate Units
SPRING_RATE_UNITS
Index RO /
Mode
Number RW
102.11 RW ALL
103
103.1 RO N/A
103.2 RO N/A
103.3 RO N/A
103.4 RO N/A
103.5 RO N/A
103.6 RO N/A
103.7 RO N/A
103.8 RO N/A
AUTO
103.9 RW MAN
OOS
1=None
2=Calibration
104 RW ALL
3=Setup & Calibration
4=All
105
1=PD On
AUTO
105.1 RW
MAN 2=PD Off
1=Not Running
105.2 RO ALL
2=Running
105.3 RW ALL 0
105.4 RW ALL
C=1001
106 RW ALL
F=1002
kPa=1133
bar=1137
AUTO
psig=1143
107 RW MAN
inHg=1155
OOS
inH2O=1146
Kg/cm
cm=1012
mm=1013
108 RW ALL
in=1019
2
cm =1025
2
109 RW ALL mm =1027
2
in =1030
N/m=1165
110 RW ALL
lb/in=1596
Range Initial Value
0
-9999.99 F
Undefined
9999.99 F
Undefined
0.0 psig
Undefined
9999.99 psig
Undefined
0
1=None (after
Restart w/Defaults)
2=Calibration
(from the factory)
1=PD On
0
C
kPa
2
=1145
mm
2
cm
N/m
DVC6200f Digital Valve Controller
Detailed Setup - Transducer Block
Protect
Description
Category
ALL Data Type: UINT16
These parameters can only reset
through VL/DD.
Data Type: Float
N/A
Highest temperature recorded
N/A Data Type: Time Value
Data Type: Float
N/A
Lowest temperature recorded
N/A Data Type: Time Value
Data Type: Float
N/A
Highest supply pressure recorded
N/A Data Type: Time Value
Data Type: Float
N/A
Lowest supply pressure recorded
N/A Data Type: Time Value
SETUP Not used by the DVC6200f
Data Type: Enum
Write lock enable/disable. If setting
is at or above a parameters
NONE
protection level then that parameter
is read‐only.
Data Type: Enum
NONE
Controls whether PD will run or not.
Data Type: Enum
NONE
Status of performance diagnostics.
Data Type: Bit String
NONE Bit string for configuring PD setup
and options.
Data Type: Uint32
NONE Extra 32 bit integer for sending
values to PD.
SETUP Data Type: Enum (Uint16)
SETUP Data Type: Enum (Uint61)
Data Type: Enum (Uint8)
Not used for spec sheet
SETUP
ACTUAL_TRAVEL OR RATEDTRAVEL
SETUP Data Type: Enum (Uint8)
SETUP Data Type: Enum (Uint8)
February 2017
99