Fisher FIELDVUEDVC6200f Instruction Manual page 70

DVC6200f Digital Valve Controller
Detailed Setup - Transducer Block
February 2017
D Push Down To (PUSH_DOWN_TO [101.6]) Enter the effect on valve movement when the stem is moved down .
D Flow Tends To (FLOW_TENDS_TO [101.7]) Enter the effect on valve travel with increasing flow.
D Enter the valve Unbalanced Area (UNBALANCED_AREA [101.8]) in in
Actuator
D Enter the Actuator Manufacture identification number (ACT_MAN_ID [47]) of the actuator on which the instrument
is mounted. Select from the drop‐down list or enter the manufacturer's identification number as defined by the
Fieldbus Foundation. For Fisher, the manufacturer ID hex value is 005100.
D Enter the Actuator Model Number (ACT_MODEL_NUM [48]) on which the instrument is mounted.
D Select the Actuator Style (ACTUATOR_STYLE [67.1]), spring & diaphragm, piston double‐acting without spring,
piston single‐acting with spring, or piston double‐acting with spring.
D Enter the Actuator Serial Number (ACT_SN [49]) for the actuator on which the instrument is mounted.
D Enter the Actuator Size (ACT_SIZE_ENUM [102.11]) of the actuator on which the instrument is mounted.
D Actuator Fail Action (ACT_FAIL_ACTION [46]) sets the actuator action to be performed upon loss of actuator air
pressure.
D Feedback Connection—Refer to table 4‐10 for Feedback Connection options. Choose the assembly that matches the
actuator travel range.
Note
As a general rule, do not use less than 60% of the magnet assembly travel range for full travel measurement. Performance will
decrease as the assembly is increasingly subranged.
The linear magnet assemblies have a valid travel range indicated by arrows molded into the piece. This means that the hall sensor
(on the back of the DVC6200f housing) has to remain within this range throughout the entire valve travel. The linear magnet
assemblies are symmetrical. Either end may be up.
Table 4‐10. Feedback Connection Options
Magnet Assembly
SStem #7
SStem #19
SStem #25
SStem #38
SStem #50
SStem #110
SStem #210
SStem #1 Roller
RShaft Window #1
RShaft Window #2
RShaft End Mount
70
Travel Range
mm Inch
4.2-7 0.17-0.28
8-19 0.32-0.75
20-25 0.76-1.00
26-38 1.01-1.50
39-50 1.51-2.00
51-110 2.01-4.125
110-210 4.125-8.25
> 210 > 8.25
- -
- -
- -
Instruction Manual
2 2
or mm .
Degrees
-
-
-
-
-
-
-
60-90_
60-90_
60-90_
60-90_
D103412X012