3.5 Terminal Cover
2.
Pull forward on the terminal cover to free it from the drive.
Figure 3.6
■
Reattaching the Terminal Cover
Models CIMR-LU20008 to 20075, 40005 to 40039, and 50003 to 50027
Power lines and signal wiring should pass through the opening provided.
page 77
and
Wiring the Control Circuit Terminal on page 81
NOTICE: Equipment Hazard. Separate motor and/or braking circuit wiring (terminals, U/T1, V/T2, W/T3, +3, +2, +1,(-), B1, B2, from all
other wiring. Place motor wiring within its own conduit or cable tray with appropriate divider, and use shielded motor cable where
appropriate. Improper wiring practices could result in malfunction of drive due to electrical interference.
Reattach the terminal cover after completing the wiring to the drive and other devices.
Figure 3.7
Models CIMR- LU20085 to 20415, 40045 to 40605, and 50003 to 50027
After wiring the terminal board and other devices, double-check connections and reattach the terminal cover.
Wiring the Main Circuit Terminal on page 77
wiring.
Figure 3.8
Connect ground wiring first,
followed by the main circuit,
and then wire the control circuit.
64
Figure 3.7 Removing the Terminal Cover
for details on wiring.
Connect ground wiring first,
followed by the main circuit,
and then wire the control circuit.
Power lines and signal wiring
exit through the opening provided.
Figure 3.8 Reattaching the Terminal Cover
and
Wiring the Control Circuit Terminal on page 81
Figure 3.9 Reattaching the Terminal Cover
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
YEA_common
Refer to Wiring the Main Circuit Terminal on
YEA_common
YEA_common
Refer to
for details on