YASKAWA L1000A Technical Manual page 401

No.(Addr.) Name
d1-26
(2C8H)
Leveling Speed
d1-27
Motor 2 Speed Reference
(2C9H)
d1-28
Leveling Speed Detection Level
(2CAH)
d1-29
Inspection Speed Detection Level
(2CBH)
<6> Setting ranges and defaults vary by the setting units determined by parameter o1-03.
Refer to Defaults and Setting Ranges by Display Unit Selection (o1-03) on page
■ d6: Field Forcing
No.(Addr.) Name
d6-03
Field Forcing Selection
(2A2H)
d6-06
Field Forcing Limit
(2A5H)
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
Description
All Modes
Sets leveling speed reference when d1-18 = 1 or 2.
V/f OLV
Sets the speed reference for motor 2.
Note:
1. If set to 0.00, the drive will control motor 1 instead.
2. When using motor 2, be sure that the accel/decel times are set in parameters C1-12 and
C1-13.
All Modes
Used when d1-18 = 0 or 3. If the speed reference selected is lower than d1-28, then the drive
uses the leveling speed as the speed reference.
All Modes
Used when d1-18 = 0 or 3. If the speed reference selected is higher than d1-28 but lower or
equal to d1-29, then the drive uses inspection speed as the speed reference.
Description
V/f OLV
0: Disabled
1: Enabled
V/f OLV
Sets the upper limit of the excitation current command during magnetic field forcing. A setting
of 100% is equal to motor no-load current. Disabled only during DC Injection Braking.
CLV CLV/PM
442.
CLV CLV/PM
CLV CLV/PM
B.3 Parameter Table
Setting Page
Default: 8.00%
<6>
common_
TMonly Min: 0.00% 184
Max: 100.00%
<6>
common_
TMonly
Default: 0.00 Hz
Min: 0.00 Hz 185
Max: 200.00 Hz
common_
Default: 0.0%
TMonly
Min: 0.0% 185
Max: 100.0%
common_
Default: 0.0%
TMonly
Min: 0.0% 185
Max: 100.0%
Setting Page
common_
Default: 0
TMonly
Min: 0 186
Max: 1
common_
Default: 400%
TMonly
Min: 100% 186
Max: 400%
B
401