YASKAWA L1000A Technical Manual page 365

Crimp Terminals
Yaskawa recommends using CRIMPFOX 6 by Phoenix Contact or equivalent crimp terminals with the specifications
listed in Table 8.11 for wiring to ensure proper connections.
Note: Properly trim wire ends so loose wire ends do not extend from the crimp terminals.
6 mm
d1 d2
(0.24 in.)
L
6.
Route the option wiring.
Depending on the drive model, some drives may require routing the wiring through the side of the front cover to
the outside. For drive models CIMR-LU20008 through 20033, 40005 through 40018, and 50003
through 50010, cut out the perforated openings on the left side of the drive front cover as shown in
Figure 8.14-A and leave no sharp edges to damage wiring.
Route the wiring inside the enclosure as shown in
20415, 40024 through 40605, and 50013 through 50200 that do not require routing through the front
cover.
Figure 8.12
A – Route wires through the openings
provided on the left side of the
front cover.
(CIMR-LU20008 through 20033,
40005 through 40018, and
50003 through 50010)
<1> The drive will not meet IP20/NEMA 1, UL Type 1 requirements if wiring is exposed outside the
enclosure.
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
Table 8.11 Crimp Terminal Sizes
Wire Gauge
Phoenix Contact Model
mm
2
AI 0.25 - 6YE
0.25 (24 AWG)
AI 0.25 - 6BU
0.34 (22 AWG) AI 0.34 - 6TQ
0.5 (20 AWG) AI 0.5 - 6WH
A
<1>
Figure 8.14 Wire Routing Examples
L
mm (in)
10.5 (13/32)
10.5 (13/32)
12 (15/32)
Figure 8.14-B for drive models CIMR-LU20047 through
B – Use the open space provided
inside the drive to route option
wiring.
(CIMR-LU20047 through 20415,
40024 through 40605, and
50013 through 50200)
8.4 Option Card Installation
d1 d2
mm (in) mm (in)
0.8 (1/32) 2 (5/64)
0.8 (1/32) 2 (5/64)
1.1 (3/64) 2.5 (3/32)
B
8
365