YASKAWA L1000A Technical Manual page 253

o2-03: User Parameter Default Value
■
After completely setting up drive parameters, save the values as user-set defaults with parameter o2-03. After saving the
values, parameter A1-03 (Initialize Parameters) will offer the choice of "1110: User Initialize". Selecting 1110 resets all
parameters to the user-set default values.
initialization.
No.
o2-03
Setting 0: No change (awaiting command)
Setting 1: Set User Initialize values
The current parameter settings are saved as user-set default for a later User Initialization. Setting o2-03 to 1 and pressing
the ENTER key saves the values and returns the display to 0.
Setting 2: Clear User Initialize Values
All user-set defaults for "User Initialize" are cleared. Setting o2-03 to 2 and pressing the ENTER key erases the values
and returns the display to 0.
o2-04: Drive Model Selection
■
This parameter must be set when replacing the control board or the terminal board for any reason. For information on the
drive model selection, refer to
NOTICE: Drive performance will suffer and protective functions will not operate properly if the correct drive capacity is not set to o2-04.
No.
o2-04
■ o2-05: Speed Reference Setting Method Selection
Determines if the ENTER key must be pressed after changing the speed reference using the digital operator while in the
Drive Mode.
No.
o2-05
Setting 0: ENTER key required
Every time the speed reference is changed using the digital operator, the ENTER key must be pressed for the drive to
accept the change.
Setting 1: ENTER key not required
The output speed changes immediately when the reference is changed by the up or down arrow keys on the digital
operator. The ENTER key does not need to be pressed. The speed reference is saved for 5 s after it is changed.
The operator display flashes when settings can be made for the frequency reference.
Figure 5.47
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
Refer to A1-03: Initialize Parameters on page 161
Parameter Name
User Parameter Default Value
Defaults by Drive Model Selection (o2-04) on page
Parameter Name
Drive Model Selection
Parameter Name
Speed Reference Setting Method Selection
Figure 5.47 Ready for Setting Speed Reference
5.10 o: Operator Related Settings
for details on drive
Setting Range
0 to 2
438.
Setting Range
–
Setting Range
0 or 1
common_TMonly
Default
0
Default
Determined by drive
capacity
Default
0
5
253