[Cme8] Updating Of Access Blade Firmware - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
E8
FUNCTION:
This command is used to update the Access blade (Line/Trunk blades) firmware by PCPro/CAT opera-
tion.
NOTE: The access blade firmware is supplied with the basic software of the CPU. Therefore, when
executing the firmware update, execute the firmware update by this command after the update
of the basic software is completed.
PRECAUTION:
(1) To execute the firmware update, the appropriate blade must be in normal operation condition.
(2) For a firmware update, the firmware supplied with the basic software in the Unit is downloaded.
(3) The firmware update is executed on a blade basis. The firmware update for multiple blades at a
time cannot be executed (this condition is also applied in the case of a multiple Unit configuration).
(4) The update period of the firmware takes about 2-3 minutes depending on the file size.
UPDATING OF ACCESS BLADE FIRMWARE
3-529
CME8
Continued on next page
NWA-033623-001 Rev.3.0
91ch3008.fm
JULY/18/2008