NEC UNIVERGE SV8300 Command Manual page 78

COMMAND CODE TITLE:
08
028 C.O. to C.O. transfer by station or attendant
NOTE:
This data is effective for C.O. trunks (Ground Start/
Loop Start) which receive a release signal from the
C.O.
029 When tandem call duration passes a predetermined time, the
call is disconnected or continued
(Related Command: CM35 Y=119, CM41 Y=0>54)
032 When a dial-in incoming call from a tie line or DID line is
addressed to vacant levels or unassigned stations, the call is
routed to a predetermined station, Attendant Console or Voice
Response System
034 Receiving Tone when the destination goes on-hook while a line
is connecting to a destination.
[For EU]
NOTE: In Germany, you have to set setting data to 0.
035 Toll Restriction for an outgoing call by Station Speed Dialing
036 Buzzer indication when a call remains held at Attendant
Console over a preprogrammed period of time assigned by
CM41 Y=0>00 Buzzer indication for Automatic Recall
[8300R2]
037 Select the detection method of incoming Ground Start trunks
Ring signal
NOTE:
This is useful when AC induction is present on Ground
Start trunks.
040 SMDR output for Tandem call
043 System Speed Dialing Security. Stored number display on Mul-
tiline Terminal for an outgoing call by System Speed Dialing.
044 Toll Restriction for an outgoing call by System Speed Dialing
045 Warning Tone sent to connected parties during Executive Right
of Way (Executive Override), Busy Verification or Attendant
Override
BASIC SERVICES
BASIC SERVICE
0 To allow
1 Not allowed
0 To disconnect
1 To continue
0 Restricted (ROT connection)
1 Predetermined station, DESKCON or
Voice Response System assigned by
CM51 Y=06, 07
0 BT
1 ROT
0 Not provided
1 Provided
0 Not available
1 Available
0 Detect only, Ring cycle only
1 Detect Ring cycle and Ground Lead
0 Available
1 Not available
0 Not displayed
1 Display
0 Not provided
1 Provided
0 Only once
1 Every 4 seconds
3-29
: Default
SETTING DATA
Continued on next page
NWA-033623-001 Rev.3.0
91ch3001.fm
NOVEMBER/12/2008
CM08