NEC UNIVERGE SV8300 Command Manual page 276

COMMAND CODE TITLE:
35
Y
No. MEANING
004 Answer signal from distant
office for outgoing connec-
tion
005 Release signal from distant
office for outgoing connec-
tion or incoming connection
008 Sending dial pulse on outgo-
ing call
009 Incoming connection signal-
ing
BLADE RESET
IPT (P2P CCIS) RESET
NOTE:
When using the COT blade, this command has never required a reset of any kind.
010 2nd DT sending on call
termination
TRUNK ROUTE DATA
DATA
0 Answer signal arrives (12 kHz, 50 Hz Metering
signal) (C.O. line)
1 Battery Reversal (C.O. line)
2 Answer signal arrives
(Tie line/ISDN/CCIS/SIP)
3 Answer signal does not arrive
(Polarity Reversal is ignored and answer timing
shall be set by CM41Y=0>03)
7 Answer signal does not arrive (Tie line/No
metered C.O. line, Answer timing shall be set
by CM41 Y=0>03)
0 Release signal does not arrive
(Ground Start/Loop Start C.O. line without
Release signal)
1 Release signal arrives
(Tie line/Ground Start/Loop Start with Release
signal/DID/ISDN/SIP)
1 No dial pulses are sent out (Speaker Paging)
2 Dial pulses are sent out: For test
(Release the resister/sender when the calling
station is on-hook)
3 Dial pulses are sent out (C.O. line/Tie line/
Radio Paging)
01 Ring Down (Ground Start C.O. line)
03 Wink Start/CCIS/SIP
04 Delay Dial
RESET
05 Immediate Start
06 2nd DT/Timing Start-Tie line
08 ISDN/Q931a
15 Ring Down (Loop Start C.O. line)
0 2nd DT is not sent (DID, etc.)
1 2nd DT is sent
SETTING DATA
MEANING
3-227
CM35
: Default
RELATED
COMMAND
CM41 Y=0
CM35 Y=020
Continued on next page
NWA-033623-001 Rev.3.0
91ch3003.fm
JULY/18/2008