NEC UNIVERGE SV8300 Command Manual page 444

COMMAND CODE TITLE:
76
Y
No. MEANING
39 Multiline Termi-
nal Ringer Tone
Pattern for DID
incoming call
with no CLI
NOTE 1:
This command is effective when CM76 Y=34, 36 is set to 0 or 2, and Multiline Terminal receives the
incoming call.
NOTE 2:
For details of the Ringer Tone Pattern see
40 Kind of call
termination
indicator key/
lamp on Atten-
dant console for
DID incoming
call with no CLI
[8300R2]
NOTE: The command is effective when CM76 Y=34, 36 is set to 0, and the destination of call forwarding is
Attendant console.
41 Mobility Access
function to each
DID number
90 Number Conver-
sion Block No.
for Development
Table 1
DIGIT CONVERSION ON DID CALL
1ST DATA
DATA
000-999:
Number Conver-
sion Block No.
assigned by
CM76 Y=00/90
000-999:
Number Conver-
sion Block No.
assigned by
CM76 Y=00/90
000-999:
Number Conver-
sion Block No.
assigned by
CM76 Y=00/90
X-XXXXXXXX:
DID number
NONE
2ND DATA
MEANING
0 Ringer Tone Pattern 0
1 Ringer Tone Pattern 1
2 Ringer Tone Pattern 2
3 Ringer Tone Pattern 3
4 Ringer Tone Pattern 4
5 Ringer Tone Pattern 5
6 Ringer Tone Pattern 6
7 As per CM76 Y=23
CM65 Y=40.
0 C.O. Incoming Call 0
1 C.O. Incoming Call 1
6 C.O. Incoming Call 6
7 As per CM35 Y=015
0 To use Mobility Access termination
1 To set Mobility Access mode
2 To cancel Mobility Access mode
7 Not used Mobility Access function
000 Number Conversion Block No. 000
999 Number Conversion Block No. 999
No data
3-395
CM76
: Default
REMARKS
CM65 Y=40
CM76 Y=23,
34, 36
CM35
Y=015
CM76 Y=34,
36
CM15
Y=216
CM64 Y=10
CM35
Y=170-172
Continued on next page
NWA-033623-001 Rev.3.0
91ch3005.fm
NOVEMBER/12/2008