NEC UNIVERGE SV8300 Command Manual page 104

COMMAND CODE TITLE:
08
432 Forced release when called ISDN Telephone does not answer
during 3 minutes
434 ISDN CPN (Calling Party Number) when making a call from
ISDN Telephone
441 Recall display on Attendant Console
442 UCD Busy Out from Sub line
443 Type of Voice Mail System (VMS)
444 Message Waiting lamp control from VMS with MCI to all
stations
NOTE: MW lamp control is only available to stations in the op-
posite PBX connected with CCIS via MCI. Station dial-
ing MW access codes are not allowed over CCIS.
445 Pressing Paging key on DESKCON when the attendant is in
idle
448 When Multiline Terminal station dials "*#" during setting of
One-Touch keys
449 DID call to station with Call Forwarding-No Answer-CCIS set
to a busy destination station.
Destination has no call forwarding set.
450 Fault Information Storing
460 Send OAI SMFN STS (status) for Call Transfer from station
461 Send OAI SMFN when answering held call
462 Send ANI/Caller ID/CPN to OAI terminal
BASIC SERVICES
BASIC SERVICE
0 Not available
1 Available
0 CPN entered in ISDN Telephone
1 CPN assigned by CM12 Y=12/13
0 Available
1 Not available
0 Available
1 Not available
0 As per CM12 Y=25
1 VMS with DTMF signaling
0 Available
1 Not available
0 Available
1 Not available
0 "*#" is set as dialed digit
1 "*#" is set as a delimiter mark
between dialed number and DTMF
signal
0 Ring continuously at forwarded DID
station
1 Drop to busy signal after time set by
CM41 Y=0>01
0 Not stored
1 To store
0 SMFN STS=7
1 SMFN STS=0
0 To send
1 Not sent
0 Available
1 Not available
3-55
: Default
SETTING DATA
Continued on next page
NWA-033623-001 Rev.3.0
91ch3001.fm
NOVEMBER/12/2008
CM08