NEC UNIVERGE SV8300 Command Manual page 124

COMMAND CODE TITLE:
0B
(4) There are the following conditions when setting the Default Gateway Address by this command.
• Only one default gateway address can be set for the system.
• Set the Default Gateway Address to the Maintenance port (Y=0XX) when not using VoIPDB.
• Set the Default Gateway Address to the VOIP port (Y=1XX) when using VoIPDB.
(5) When setting the IP Address (RTP) for VoIPDB by CM0B Y=2XX, the number of IP Addresses
that can be set is different depending on the type of VoIPDB used.
• For PZ-64IPLA: maximum of 4 IP Addresses can be set (Y=2XX>00, 20-22)
• For PZ-128IPLA: maximum of 8 IP Addresses can be set (Y=2XX>00, 20-26)
Set an IP address (RTP) every 16 voice channels to be used.
(6) When entering data with characters, the following characters can be registered;
Alphabet upper case (A-Z), alphabet lower case (a-z), numeric (0-9), symbol (! " # $ % & ' ( ) + ,
; = > ? @ [ ] ^ _ ' { } ~), Space, hyphen (-), period (.), slash (/), colon (:)
NOTE:
The character "CCC" cannot be registered.
ASSIGNMENT PROCEDURE:
+ 0BYYY + DE
ST
LAN DATA ASSIGNMENT
1ST DATA
+ + DE
(2-3 digits)
2ND DATA
+ +
EXE
(1-128 digits)
3-75
CM0B
RESET
NWA-033623-001 Rev.3.0
91ch3001.fm
JULY/18/2008