[Cm72] Stored Number For System Speed Dialing - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
72
FUNCTION:
This command is used to enter the stored number or character for System Speed Dialing feature into the
memory allocated with CM71.
PRECAUTION:
(1) When displaying the data, the access code corresponding to the Memory Slot number is indicated
by the very first
digits of the stored number exceeds 16, the 17th to 26th digits are indicated by the next
(2) Data can only be changed when the access code is displayed. Enter the data in the following order;
new access code, comma, the called number, and
.
EXE
(3) If "C" is inserted in the called number, when using System Speed Dialing for an outgoing Tie Line
call, it can be used as a fixed-length pause (1.5 seconds). To provide a programmable pause with
the stored number, insert "D" instead of "C". The length of the programmable pause is assigned
with CM41 Y=0>38.
(4) The stored number, for System Speed Dialing, is assigned for each Memory Slot number, not for
the abbreviated code of each calling party. When assigning stored numbers, the correspondence
between Memory Slot numbers and abbreviated codes is first to be determined for each kind of
calling party, and then the stored numbers are to be assigned according to the determined
correspondence, with each exclusive memory area assigned in CM71 taken into consideration.
(5) When entering data with characters, the following characters can be registered;
Alphabet upper case (A-Z), alphabet lower case (a-z), numeric (0-9), symbol (! " # $ % & ' ( ) + ,
; < = > ? @ [ ] ^ _ ' { } ~), Space, hyphen (-), period (.), slash (/), colon (:)
NOTE: The character "CCC" cannot be registered.
ASSIGNMENT PROCEDURE:
ST + 72Y + DE +
STORED NUMBER FOR SYSTEM SPEED DIALING
, and the stored number is indicated by the next
DE
MEMORY SLOT NUMBER
(3 digits)
EXE . For clearing the data, enter "CCC", and
STORED NUMBER
+ DE +
(Maximum 32 digits)
3-377
CM72
. When the number of
DE
.
DE
+ EXE
NWA-033623-001 Rev.3.0
91ch3005.fm