NEC UNIVERGE SV8300 Command Manual page 302

COMMAND CODE TITLE:
35
Y
No. MEANING
290 Setting of PAD data from a
station to a trunk
See PRECAUTION (3)
NOTE 1:
This command is effective for the following trunks.
- LDT/ODT/PRT/DTI/CCT/SIP/IPT (P2P CCIS)
NOTE 2:
For PAD data from a BRT to a station, 0 (Transmit) and -6 (Receive) is set as a fixed PAD data.
291 CODEC Filter Type
BLADE RESET
See PRECAUTION (3)
NOTE 1: This command is effective for the data set for the trunk route of the base port of each COT/LDT/ODT
blade (All ports of the blade including COTDC become the same setting).
NOTE 2: For the second data, signal losses in the line distance of the line are estimated as follows.
Second data: 01 (TYPE1 [Very short distance])........ 0 dB
NOTE 3: For a COT blade, set the second data depending on the line distance of the ordinary line as follows.
- Set the second data to "01" (TYPE1 [Very short distance]) when connecting to the behind PBX, TA
and IP telephone adapter.
- Set the second data to "03" (TYPE3 [Long distance]) when the line is far from the Office PBX and
the signal loss is large.
NOTE 4:
For a LDT/ODT blade, set the second data depending on the line distance of the line.
999 Returning all trunk route
data to default settings
TRUNK ROUTE DATA
DATA
01 -15 dB
15 -1 dB
16 0 dB
17 +1 dB
31 +15 dB
NONE 0 dB
+: Gain
- : Loss
00 Not filtered
01 TYPE1 (Very short distance)
02 TYPE2 (Middle distance)
03 TYPE3 (Long distance)
NONE TYPE2 (Middle distance)
: 02 (TYPE2 [Middle distance]) ............. 4 dB
: 03 (TYPE3 [Long distance]) ................ 8 dB
CCC Return to default settings
NOTE 1:
All trunk route data by CM35 set to each trunk route will return to de-
fault settings if this command is used.
NOTE 2:
This data is effective also when the system is under on-line mode.
SETTING DATA
MEANING
(1 dB increment)
(1 dB increment)
3-253
CM35
: Default
RELATED
COMMAND
Continued on next page
NWA-033623-001 Rev.3.0
91ch3003.fm
NOVEMBER/12/2008