[Cm94] Multiline Terminal One-Touch Memory - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
94
FUNCTION:
This command is used to assign memory for the storage of numbers accessed by the one-touch keys on
a Multiline Terminal.
PRECAUTION:
Do not duplicate the same memory area for CM73 and CM94 usually. However, when Dial by Name
feature using one-touch keys or BLF on Multiline Terminal line key feature are provided, the same mem-
ory areas must be specified by CM73 and CM94.
ASSIGNMENT PROCEDURE:
+ 94 + +
DE
ST
DATA TABLE:
MY LINE NUMBER
X
XXXXXXXX
NOTE: If assigning the station number to One Touch keys using 1000-Slot Memory Block number
4-9, the lamp does not show the busy state.
MULTILINE TERMINAL ONE-TOUCH MEMORY
MY LINE
NUMBER
+ +
DE
(1-8 digits)
DATA
WW XX Y ZZ
NONE
DATA
+
EXE
(7 digits)
SETTING DATA
WW: 1000-Slot Memory Block number (00-19)
XX : 10-Slot Memory Start Block number (00-99)
Y : Facility for programming the dialed number from the
station
(0/1=Effective/Ineffective)
ZZ : Number of 10-Slot Memory Blocks (01-10)
01: Multiline Terminal (10 memories)
02: Multiline Terminal (20 memories)
03: Multiline Terminal (30 memories)
04: Multiline Terminal (40 memories)
05: Multiline Terminal (50 memories)
06: Multiline Terminal (60 memories)
07: Multiline Terminal (70 memories)
08: Multiline Terminal (80 memories)
09: Multiline Terminal (90 memories)
10: Multiline Terminal (100 memories)
No data
3-451
MEANING
NWA-033623-001 Rev.3.0
CM94
: Default
NOTE
91ch3006.fm