NEC UNIVERGE SV8300 Command Manual page 42

CONDITION
Commands which require a
reset of the blade after data
setting.
• Executed by CME0 Y=3
BLADE RESET
Commands which can be
used only under Off-Line
mode of the CPU blade. See
"METHOD OF SETTING
ON-LINE/OFF-LINE
MODE". Page 2-6
OFF LINE
Commands which require a
reset of the IPT (P2P CCIS)
after data setting.
• Executed by CME0
Y=5>01
IPT (P2P CCIS) RESET
NOTE:
Before the CPU blade is placed into Off-Line mode, the system data backup must be executed
by CMEC Y=6>0: 0.
Conditions for Using Commands
COMMANDS
CMAE Y=00>03-05
Y=10, 11, 15, 19
CMEE Y=0-3
CM00
CM01
CM0B Y=000
CMEC Y=7
NOTE
CM4A Y=90
CM0B Y=1XX>34, 35
CM10 Y=02
CM30 Y=00
CM35 Y=000, 009, 020
CMA7 Y=44, 46, 50
CONDITIONS FOR USING COMMANDS
CS/ZT Operation Data Assignment
Application Blade Data Assignment
System Data Memory All Clear/Billing Mem-
ory Clear
System Data Memory Partial Clear
LAN Data Assignment
Maintenance by PCPro/CAT
Day/Night Mode Change by System Clock
LAN Data Assignment
Station Number, Trunk Number, Blade Num-
ber
Trunk Data
Trunk Route Data
CCIS Channel Data/IP Trunk Data/SIP Trunk
Data
2-5
Chapter 2 PRECAUTION
MEANINGS
NWA-033623-001 Rev.3.0
NOVEMBER/12/2008
91ch2001.fm