NEC UNIVERGE SV8300 Command Manual page 90

COMMAND CODE TITLE:
08
212 When a caller encounters all ACD/UCD stations busy
213 Method to cancel Call Forwarding-All Calls/-Busy Line/-No
Answer
214 When a ACD/UCD station dials ACD/UCD Busy out code after
holding the call from a Tie Line/CCSA line on Consultation
Hold
215 When a ACD/UCD station dials ACD/UCD Busy out code after
holding the call from C.O. Line (DDD/FX/WATS) on Consulta-
tion Hold
216 Processor for Authorization Code/Forced Account Code
217 Processor for Remote Access to System (DISA) Code
220 Burst tone for Operator Monitoring
[Australia Only]
221 Tone sent to all parties on three party conference
NOTE:
Setting data 0 is effective only when CM31 Y=0>0 is
04.
BASIC SERVICES
BASIC SERVICE
0 Busy Tone is to be sent out
1 Caller is placed into queuing mode
0 Feature access code + Feature key
1 Feature access code + "*" key
0 ACD/UCD station hears Service Set
Tone, and returns to the call by Switch
Hook Flash
See CM17 Y=6 1 The call is disconnected, and the
ACD/UCD station hears ROT
0 ACD/UCD station hears Service Set
Tone, and returns to the call by Switch
Hook Flash
See CM17 Y=5 1 The call is disconnected, and the
ACD/UCD station hears ROT
0 To provide
1 Not provided (OAI)
0 To provide
1 Not provided (OAI)
0 Only Once
1 Every 4 seconds
0 Tone is not sent
1 Every 4 seconds
3-41
: Default
SETTING DATA
See CM2A Y=00-14, A0
See CM2A Y=00-14, A0
Continued on next page
NWA-033623-001 Rev.3.0
91ch3001.fm
JULY/18/2008
CM08