NEC UNIVERGE SV8300 Command Manual page 96

COMMAND CODE TITLE:
08
BASIC SERVICE: 301-398
301 When system is reseted
311 Display last calling station number
Display calling station number when a calling station abandons
a call before the call is answered
313 An Incoming call via UCD station in Exclusive Hold/Remote
Hold
319 On a Tie Line outgoing call with answer signal, transferring/
holding the call before distant called station answers.
NOTE: Effective only when CM35 Y=000 is 03 or 04 and
CM35 Y=004 is 02.
322 Answering method of Camp-On (Call Waiting Method)
324 Direct-In Termination-Outside
(In the case of no release signal on incoming trunk and both
answer and release signals on outgoing trunk)
[8300R2]
331 Sender Prepause for outgoing call via attendant
333 Mail box number sent to VMS when VMS is recalled after
transferring the call to an unanswered station
334 Call to station set with a Return Message Schedule
Display, receives ringing
335 Station number and name display when incoming call begins
ringing in
BASIC SERVICES
BASIC SERVICE
0 Multiline Terminal MIC lamp ON
1 Multiline Terminal MIC lamp OFF
0 6 seconds
1 Until next call
0 Not available
1 Available
0 Not income
1 To income
0 Not available
1 Available
0 Same as Camp-On transfer-method
(Switch Hook Flash + Call Hold
access code/Answer key)
1 Alternating between two calls by
Switch Hook Flash/Answer key
0 After the outgoing trunk receives the
response, the tandem connection is
allowed
1 The tandem connection is restricted
when the incoming trunk is no resto-
ration signal
0 To provide
1 Not provided
0 To send
1 Not sent
0 Available (Ringing)
1 Not available (ROT connection)
0 Display when incoming call termi-
nates to the Prime Line
1 Display when incoming call termi-
RESET
nates to the Prime Line or My Line
3-47
: Default
SETTING DATA
Continued on next page
NWA-033623-001 Rev.3.0
91ch3001.fm
NOVEMBER/12/2008
CM08