NEC UNIVERGE SV8300 Command Manual page 125

COMMAND CODE TITLE:
0B
DATA TABLE:
Y=0XX
Y
No. MEANING
0XX 0 : Maintenance Port
XX: Unit No. (01-50)
LAN DATA ASSIGNMENT
1ST DATA
DATA MEANING
00 IP Address for the sys-
tem
NOTE 1:
This data cannot be entered by CAT when using 8300R1 software.
NOTE 2:
When setting the IP address by this data, a period (.) must be entered
between the numbers (example: 255.255.255.254).
01 Subnet Mask for the
system
NOTE 1: This data cannot be entered by CAT when using 8300R1 software.
NOTE 2: When setting the Subnet Mask by this data, a period (.) must be
entered between the numbers (example: 255.255.255.252).
02 Default Gateway for the
system
NOTE 1: This data cannot be entered by CAT when using 8300R1 software.
NOTE 2: When setting the Default Gateway by this data, a period (.) must be en-
tered between the numbers (example: 255.255.255.254).
09 Speed mode for the LAN
Interface
2ND DATA
DATA
XXX.XX IP Address
...X (Maximum 15 digits)
XXX.XXX.XXX.XXX=
0.0.0.1-255.255.255.254
NONE No data
XXX.XX Subnet Mask
...X (Maximum 15 digits)
XXX.XXX.XXX.XXX=
255.0.0.0-255.255.255.252
NONE No data
XXX.XX Default Gateway
...X (Maximum 15 digits)
XXX.XXX.XXX.XXX=
0.0.0.1-255.255.255.254
NONE No data
02 100 Mbps (Full-Duplex)
03 100 Mbps (Half-Duplex)
04 10 Mbps (Full-Duplex)
05 10 Mbps (Half-Duplex)
15 Auto Negotiation
3-76
RESET
: Default
RELATED
COMMAND
MEANING
Continued on next page
NWA-033623-001 Rev.3.0
NOVEMBER/12/2008
CM0B
91ch3001.fm