NEC UNIVERGE SV8300 Command Manual page 91

COMMAND CODE TITLE:
08
222 To complete the operation for setting Call Forwarding-All
Calls-Outside/Busy Line-Outside/No Answer-Outside
227 Whether the transferred C.O. call from station or attendant is
placed into queuing mode when all ACD/UCD stations are busy
NOTE: Effective only when CM08>212 is set to 1.
228 Ringing start time for Wake Up call/Timed Reminder call
229 Choice of Night Service via DESKCON Programming Mode
232 Trunk access from station in Room Cutoff status
233 Message Waiting lamp of calling station is extinguished when
an attendant answers
[8300R2]
234 Deletion of Call History-No Answer/Message Waiting irrespec-
tive of the station answering when calling back to Call History-
No Answer/Message Waiting
235 Deletion of all stored Call History-No Answer/Message Wait-
ing of calling station when answering the call
236 Special Dial Tone sending for Attendant Console or station dial-
ing a Message Waiting access Set/Cancel code
237 Automatic Intercom to station set for Do Not Disturb
238 Ringing of Manual Intercom call on station set for Do Not Dis-
turb
BASIC SERVICES
BASIC SERVICE
0 Setting when the station goes on
hook/when receiving Service Set
Tone (ORT time out)
1 Setting when receiving Service Set
Tone (ORT time out)
0 The call is placed into queueing mode
1 Recall to the transferring station when
the call is transferred from station, or
Attendant Camp-On is set when the
call is transferred from Attendant
0 Start at preset time
1 Start at the time 5 minutes before pre-
set time
0 Available
1 Not available
0 Restricted to C.O. only
1 Restricted to all Trunk Route
0 Available
1 Not available
0 To delete
1 Not deleted
(To delete only when answering)
0 To delete
1 Not deleted
0 No tone
1 Tone is sent
0 Restricted (ROT connection)
1 Allowed
0 No ring
1 Ring on
3-42
: Default
SETTING DATA
See CM13 Y=13
Continued on next page
NWA-033623-001 Rev.3.0
91ch3001.fm
NOVEMBER/12/2008
CM08