Basic Services - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
08
FUNCTION:
This command is used to assign basic features on a system wide basis.
PRECAUTION:
After setting 1st data 335, 368, 390, 391, 392, 396, 397, 420, 592, 909, system reset is required.
ASSIGNMENT PROCEDURE:
ST + 08 + DE +
DATA TABLE:
BASIC SERVICE: 010-096
010 Operator Overlapping
[Australia Only]
011 Operator Monitoring
[Australia Only]
[8300R2]
012 Attendant Override/Busy Verification
[8300R2]
014 Attendant Loop Release
[8300R2]
018 Attendant Night Transfer
[8300R2]
020 Terminating to Attendant Console by receiving Forward GII
signal on DID MFC call
[Not used in North America]
026 Group Diversion
027 A hold tone is sent to overlap call
[Australia Only]

BASIC SERVICES

BASIC SERVICE
+ DE
FEATURE
(3 digits)
BASIC SERVICE
DATA (0/1)
+ + EXE
(1 digit)
0 Not available
1 Available
0 Not available
1 Available
0 Not available
1 Available
0 Available
1 Not available
0 Not available
1 Available
0 Not allowed
1 To allow
0 Available
1 Not available
0 To send
1 Not sent
3-28
: Default
SETTING DATA
See CM51 Y=13
See CM16 Y=2 CM19 Y=6
Continued on next page
NWA-033623-001 Rev.3.0
91ch3001.fm
NOVEMBER/12/2008
CM08