Modes Of Operation; Modes Of Operation; Basic Mode; Tdm Mode - Paradyne 3610 Application Manual

Data service units time division multiplexer, multichannel multipoint, and digital bridge options
Hide thumbs Also See for 3610:
Table of Contents

Advertisement

COMSPHERE 3600 Series Data Service Units

Modes Of Operation

A DSU with TDM or MCMP can operate in one of
four modes: TDM mode (MUX Funct: TDM), MCMP
mode (MUX Funct: MCMP), Bridge mode (MUX Funct:
CBrdg or EBrdg), or Basic mode (MUX Funct: None).
TDM and Bridge modes are available to a DSU with
TDM; TDM, MCMP, and Bridge modes are available to a
DSU with MCMP. The DSU operates in Basic mode when
the TDM or MCMP circuit card is disabled.
MUX Funct (the TDM or MCMP circuit card's
function) is the MUX Setup configuration option as it is
displayed in the Configuration (Confg) branch of the DCP
menu. The functions available in this section are TDM,
MCMP, CBrdg or EBrdg, or None (Basic). Each mode
offers a unique set of configuration options.

Basic Mode

For a DSU with TDM or MCMP, disabling the TDM or
MCMP capability (MUX Funct: None) places the DSU in
Basic mode – just as if there were no TDM or MCMP
circuit card attached to the DSU.
4-4

TDM Mode

In TDM mode, data paths are established between the
DSU and TDM to increase the port capacity of the DSU to
six ports. All six ports can be configured for multiplexing,
digital sharing, or a combination of both.
A 3600 Series DSU with TDM can also be equipped
with a dial backup module (DBM), either the V.32 DBM
or a Switched 56 DBM, for point-to-point dial backup.

MCMP Mode

In MCMP mode, the same data paths are established as
in the TDM mode of operation, plus the multichannel
multipoint circuitry is activated on the MCMP circuit
card.

Bridge Mode

In Bridge mode, all ports are assigned to one
digital-sharing group. The data paths between the DSU
and TDM or MCMP are also changed relative to the data
paths in place during TDM or MCMP mode of operation.
When the TDM or MCMP is configured as a digital
bridge, it can be used in conjunction with the control DSU
to support multipoint LADS operation, dedicated
multipoint dial backup, or expanded digital-sharing.
If a DBM is installed, it must be disabled or removed
to operate in Bridge mode.
July 1999
3610-A2-GB41-70

Advertisement

Table of Contents
loading

This manual is also suitable for:

3611Comsphere 3610Comsphere 3611Comsphere 3600 series

Table of Contents