Configuring Ip Interworking Over Local Mpls L2Vpn Connections - HP HPE FlexNetwork MSR Router Series Configuration Manual

3. Configure PE:
# Enable L2VPN.
<PE> system-view
[PE] l2vpn enable
# Create a cross-connect group named vpn1, create a cross-connect named vpn1 in the group,
and bind GigabitEthernet 2/0/1 and GigabitEthernet 2/0/2 to the cross-connect.
[PE] xconnect-group vpn1
[PE-xcg-vpn1] connection vpn1
[PE-xcg-vpn1-vpn1] ac interface gigabitethernet 2/0/1
[PE-xcg-vpn1-vpn1] ac interface gigabitethernet 2/0/2
[PE-xcg-vpn1-vpn1] quit
Verifying the configuration
# Display AC forwarding entries on the PE. The output shows two AC forwarding entries.
[PE] display l2vpn forwarding ac
Total number of cross-connections: 1
Total number of ACs: 2
AC
GE2/0/1
GE2/0/2
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)
Configuring IP interworking over local MPLS L2VPN
connections
Network requirements
CE 1 and PE are connected through Ethernet interfaces. CE 2 and PE are connected through serial
interfaces, and use PPP as the link layer protocol.
Configure local MPLS L2VPN connections between the PE and CEs and enable interworking on the
PE to allow communication between CE 1 and CE 2.
Figure 109 Network diagram
Configuration procedure
1. Configure CE 1.
<CE1> system-view
[CE1] interface gigabitethernet 2/0/1
Xconnect-group
vpn1
vpn1
424
Link ID
0
1