Configuring The Interface With Ethernet Or Vlan Encapsulation - HP HPE FlexNetwork MSR Router Series Configuration Manual

Configuring the interface with Ethernet or VLAN
encapsulation
On a Layer 3 Ethernet interface (including Layer 3 Ethernet interface, Layer 3 virtual Ethernet
interface, and VE-L2VPN interface), both the default PW type and default access mode are Ethernet.
On a Layer 3 Ethernet subinterface or VLAN interface, both the default PW type and default access
mode are VLAN.
The PW type and AC access mode determine how the VLAN tag is processed by a PE. Therefore,
the PW types and AC access modes on the local PE and the peer PE must match.
To configure the interface with Ethernet or VLAN encapsulation:
Step
1. Enter system view.
2. Enter interface view.
3. (Optional.) Specify the default
next hop IP address or MAC
address.
Configuring the interface with PPP encapsulation
Step
1. Enter system view.
2. Enter interface view.
3. Configure the link layer
protocol.
4. (Optional.) Configure IPCP
negotiation without an IP
address or specify the IPCP
proxy IP address.
Configuring the interface with HDLC encapsulation
Step
1. Enter system view.
2. Enter interface view.
3. Configure the link layer
protocol.
Command
system-view
interface interface-type
interface-number
default-nexthop { ip ip-address |
mac { mac-address | broadcast } }
Command
system-view
interface { serial | pos } number
link-protocol ppp
•
To configure IPCP negotiation
without an IP address:
ppp ipcp ignore local-ip
•
To specify the IPCP proxy IP
address:
ppp ipcp proxy ip-address
Command
system-view
interface { serial | pos } number
link-protocol hdlc
414
Remarks
N/A
N/A
Required for MPLS L2VPN
interworking.
By default, no default next hop
is specified.
This command is not supported
on a VLAN interface.
Remarks
N/A
N/A
By default, the link layer
protocol is PPP.
By default, IPCP negotiation
without an IP address is not
supported and no IPCP proxy
address is specified.
Remarks
N/A
N/A
By default, the link layer
protocol is PPP.