HP HPE FlexNetwork MSR Router Series Configuration Manual page 173

Table of Contents

Advertisement

Maximum transmission unit: 1496
Internet address: 6.1.1.1/24 (primary)
Tunnel source unknown, destination 3.3.3.3
Tunnel TTL 255
Tunnel protocol/transport CR_LSP
Output queue - Urgent queuing: Size/Length/Discards 0/100/0
Output queue - Protocol queuing: Size/Length/Discards 0/500/0
Output queue - FIFO queuing: Size/Length/Discards 0/75/0
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
# Execute the display mpls te tunnel-interface command on Router A to display detailed
information about the MPLS TE tunnel.
[RouterA] display mpls te tunnel-interface
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
Backup Bandwidth Type: -
Route Pinning
Retry Limit
Reoptimization
Backup Type
Auto Bandwidth
Min Bandwidth
Collected Bandwidth
# Execute the display mpls lsp command or the display mpls static-cr-lsp command on each
router to display static CRLSP information.
[RouterA] display mpls lsp
FEC
: Tunnel 0
: Up (Main CRLSP up)
:
: 1
Tunnel ID
: Normal
: 1.1.1.1
Egress LSR ID
: Static
Static CRLSP Name
: -
: -
: -
: -
Reverse-LSP Tunnel ID: -
: -
Tunnel Bandwidth
: -
: 0
Holding Priority
: -/-
: -
: TE
: -
Record Label
: -
Backup Bandwidth Flag: -
Backup Bandwidth
: -
: 3
Retry Interval
: -
Reoptimization Freq
: -
Backup LSP ID
: -
Auto Bandwidth Freq
: -
Max Bandwidth
: -
Proto
In/Out Label
163
: 0
: 3.3.3.3
: static-cr-lsp-1
: -
: 0
: -
: -
: 2 sec
: -
: -
: -
: -
Interface/Out NHLFE

Advertisement

Table of Contents
loading

Table of Contents