Table of Contents
Advertisement
Step
and enter auto-discovery
cross-connect group view.
4.
Configure an RD for the
cross-connect group.
5.
Configure route targets for
the cross-connect group.
6.
(Optional.) Reference a PW
class.
7.
(Optional.) Configure an
MTU for the PW.
8.
Create a local site and enter
site view.
9.
Create a cross-connect and
enter auto-discovery
cross-connect view.
10. (Optional.) Reference a
tunnel policy.
Configuring a remote CCC connection
To configure a remote CCC connection, perform the following configurations on the PE and P
devices:
•
On the two PEs, use the ccc command to specify the incoming and outgoing labels.
•
On each P device between the two PEs, use the static-lsp transit command to configure a
static LSP for each direction of the CCC connection. For more information about the static-lsp
transit command, see MPLS Command Reference.
Follow these guidelines when you configure a remote CCC connection:
•
The outgoing label specified on a device must be the same as the incoming label specified on
the next-hop device.
•
CCC connection settings such as the encapsulation type and control word feature must be
consistent on the two PEs. Otherwise, the PEs might fail to forward packets over the CCC
connection.
To configure a remote CCC connection:
Step
1.
Enter system view.
2.
Enter cross-connect
group view.
3.
Enter cross-connect
view.
4.
Create a remote
CCC connection.
Command
route-distinguisher
route-distinguisher
vpn-target vpn-target&<1-8>
[ both | export-extcommunity |
import-extcommunity ]
pw-class class-name
mtu mtu
site site-id [ range range-value ]
[ default-offset default-offset ]
connection remote-site-id
remote-site-id
tunnel-policy tunnel-policy-name
Command
system-view
xconnect-group group-name
connection connection-name
ccc in-label in-label-value
out-label out-label-value
{ nexthop nexthop |
out-interface interface-type
interface-number } [ pw-class
418
Remarks
BGP.
By default, no RD is configured for
the cross-connect group.
By default, no route targets are
configured for the cross-connect
group.
By default, no PW class is
referenced.
The default MTU is 1500 bytes.
By default, no local site is created.
By default, no cross-connect is
created.
After you execute this command,
a PW to the specified remote site
is created and is bound to the
cross-connect.
By default, no tunnel policy is
referenced.
Remarks
N/A
N/A
N/A
By default, no remote CCC connection is
created.
Use the out-interface keyword to specify
the outgoing interface only on a
Advertisement
Table of Contents
