HP HPE FlexNetwork MSR Router Series Configuration Manual page 155

Table 8 Interface and IP address assignment
Device
Router A
Router B
Router D
Configuration procedure
1. Configure IP addresses and masks for interfaces. (Details not shown.)
2. Configure IS-IS to advertise interface addresses, including the loopback interface address.
(Details not shown.)
3. Configure an LSR ID, and enable MPLS, MPLS TE, and RSVP-TE on each router. Enable BFD
for RSVP-TE on Router B and Router C:
# Configure Router A.
<RouterA> system-view
[RouterA] mpls lsr-id 1.1.1.1
[RouterA] mpls te
[RouterA-te] quit
[RouterA] rsvp
[RouterA-rsvp] quit
[RouterA] interface gigabitethernet 2/0/1
[RouterA-GigabitEthernet2/0/1] mpls enable
[RouterA-GigabitEthernet2/0/1] mpls te enable
[RouterA-GigabitEthernet2/0/1] rsvp enable
[RouterA-GigabitEthernet2/0/1] quit
# Configure Router B.
<RouterB> system-view
[RouterB] mpls lsr-id 2.2.2.2
[RouterB] mpls te
[RouterB-te] quit
[RouterB] rsvp
[RouterB-rsvp] quit
[RouterB] interface gigabitethernet 2/0/1
[RouterB-GigabitEthernet2/0/1] mpls enable
[RouterB-GigabitEthernet2/0/1] mpls te enable
[RouterB-GigabitEthernet2/0/1] rsvp enable
[RouterB-GigabitEthernet2/0/1] quit
[RouterB] interface gigabitethernet 2/0/2
[RouterB-GigabitEthernet2/0/2] mpls enable
Interface IP address
Loop0 1.1.1.1/32
GE2/0/1 2.1.1.1/24
Loop0 2.2.2.2/32
GE2/0/1 2.1.1.2/24
GE2/0/2 3.1.1.1/24
POS2/2/0 3.2.1.1/24
POS2/2/1 3.3.1.1/24
Loop0 4.4.4.4/32
GE2/0/1 4.1.1.2/24
POS2/2/0 4.2.1.2/24
Device Interface
Router E Loop0
POS2/2/0
POS2/2/1
Router C Loop0
GE2/0/1
GE2/0/2
POS2/2/0
Router F Loop0
POS2/2/0
POS2/2/1
145
IP address
5.5.5.5/32
3.2.1.2/24
3.4.1.1/24
3.3.3.3/32
4.1.1.1/24
3.1.1.2/24
3.4.1.2/24
6.6.6.6/32
3.3.1.2/24
4.2.1.1/24