Vpls Configuration Task List - HP HPE FlexNetwork MSR Router Series Configuration Manual

•
MSR3012/3024/3044/3064.
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.

VPLS configuration task list

To configure a VPLS network, perform the following tasks:
•
Configure an IGP to ensure IP connectivity within the backbone.
•
Configure basic MPLS, LDP, GRE, or MPLS TE to establish public tunnels on the backbone
network.
•
Configure VPLS on PEs. For example, configure a VSI, establish a PW, and associate an AC
and a VSI.
This chapter describes only VPLS configurations on a PE. For information about other configurations,
see relevant configuration guides.
To configure VPLS on a PE, perform the following tasks:
Tasks at a glance
(Required.)
(Required.)
(Required.)
Configuring a
•
(Optional.)
•
(Required.) Choose either of the following tasks to configure a PW:
Configuring a static PW
Configuring an LDP PW
Configuring a BGP PW
Configuring a BGP auto-discovery LDP PW
(Required.)
(Optional.) Configuring UPE dual
•
Configuring static PW redundancy
•
Configuring LDP PW redundancy
(Required.)
(Optional.) Enabling SNMP notifications for L2VPN PW
Enabling L2VPN
Before you enable L2VPN, perform the following tasks:
•
Configure an LSR ID for the PE with the mpls lsr-id command.
•
Enable MPLS with the mpls enable command on the backbone interface of the PE.
To enable L2VPN:
Step
1. Enter system view.
2. Enable L2VPN.
Enabling L2VPN
Configuring an AC
Configuring a VSI
PW:
Configuring a PW class
Binding an AC to a VSI
homing:
Configuring MAC address learning
Command
system-view
l2vpn enable
459
Remarks
N/A
N/A
N/A
Choose a PW configuration
method depending on the
VPLS implementation.
N/A
N/A
N/A
N/A
Remarks
N/A
By default, L2VPN is disabled.