Configuring An Inter-Domain Multi-Segment Pw - HP HPE FlexNetwork MSR Router Series Configuration Manual

[PE2] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpn1
Peer
192.4.4.4
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring an inter-domain multi-segment PW

Network requirements
PE 1 and ASBR 1 belong to AS 100. PE 2 and ASBR 2 belong to AS 200.
Set up an inter-domain multi-segment PW (a method for inter-AS Option B networking) within the
backbone to allow communication between CE 1 and CE 2.
Configure the inter-domain multi-segment PW as follows:
•
Configure LDP PWs between PE 1 and ASBR 1, and between PE 2 and ASBR 2, and configure
public tunnels through LDP to carry the PWs.
•
Configure an LDP PW between ASBR 1 and ASBR 2. Advertise labeled IPv4 routes between
ASBR 1 and ASBR 2 through BGP to set up the public tunnel to carry the LDP PW.
•
Concatenate the two PWs on ASBR 1.
•
Concatenate the two PWs on ASBR 2.
Figure 116 Network diagram
Table 45 Interface and IP address assignment
Device
CE 1
PE 1
PE 2
CE 2
PW ID In/Out Label
1000 200/100
Interface IP address
GE2/0/1 100.1.1.1/24
Loop0 192.1.1.1/32
GE2/0/2 23.1.1.1/24
Loop0 192.4.4.4/32
GE2/0/2 22.2.2.1/24
GE2/0/1 100.1.1.2/24
Proto Flag
Static M
Device Interface
ASBR 1 Loop0
GE2/0/2
GE2/0/1
ASBR 2 Loop0
GE2/0/1
GE2/0/2
447
Link ID State
1 Up
IP address
192.2.2.2/32
23.1.1.2/24
26.2.2.2/24
192.3.3.3/32
26.2.2.3/24
22.2.2.3/24